Jump to content

Single rail gbox onto 1300 crank


jerrytr5

Recommended Posts

I'm in the process of fitting a single rail box from a 1500 to a 1300 engine. There are clearly a number of ways of doing this, but the 'best' from my point of view would be to use the old 1500 flywheel on the 1300 crank. But the 1500 uses 7/16 bolts and the 1300 3/8inch. So, assuming the flywheel will match the dowel and the crank face all I need are some bolts with a 7/16 shank and a 3/8 thread.
Anyone tried this before and found a supplier?

Link to comment
Share on other sites

jerrytr5,
Rimmer Brothers at least used to sell RL1512 as a set of parts to fit the 1500 flywheel to the earlier cranks. I looked that up in a VERY old catalogue, so, they may not do them anymore.
                                                                           Cheers,
                                                                           Paul

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...