firebobby Posted May 23, 2010 Share Posted May 23, 2010 I'm about to start on the bodywork on the GT6, i think i'm lucky in that the car was Ziebarted from new and is not a rust bucket, it's been off the road since 1988, and only has 36490 genuine miles on the clock.Although the car has been protected, it still has some areas of rot,N/S/R sill area, N/S/R panel behind the back wheel and other small but not easy to repair areas.I want to try and keep as much original metal on the car as poss, so hope to do small localised repairs.Where can i find good fitting part panels that i can use, any ideasCheers, John Link to comment Share on other sites More sharing options...
JRidout Posted May 23, 2010 Share Posted May 23, 2010 Check out all the websites. Rimmers, James Paddock, Canley, Fitchett, Steelcraft... All are close but and I know from experience that all panels will need a bit of fettling. Patience is something you will learn!!CheersJR Link to comment Share on other sites More sharing options...
firebobby Posted May 23, 2010 Author Share Posted May 23, 2010 I've been having a another look and may try to make the panel parts i need, like i said, the bits i need are not to big.I have rebuilt 2 old Landrovers and got quite good at letting in metal.I'll see how i get onI have taken some photos of the car, so when i can figure out how to get them onto the site, i will show you mine (car)Oh, and i did look at Paddocks, good amount of stock and prices are not bad eitherCheers,John Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.