BodsMk1 Posted October 31, 2010 Share Posted October 31, 2010 Hello , could anyone give me tips on getting my door seals to fit neatly. Im havin a major problem getting them to go around the top back corner because it tighter than 90 degrees, also wheres the best place to finish the seal . All tips welcome , cheers all. Link to comment Share on other sites More sharing options...
Velocita Rosso Posted October 31, 2010 Share Posted October 31, 2010 The corners, a soft faced mallet and a small piece of soft wood , gently tapping into the cornerFinish off on the centre/upright near the hinges, the join wont be seen on immediate opening of the door Link to comment Share on other sites More sharing options...
GT6 M Posted October 31, 2010 Share Posted October 31, 2010 It will pull out /work out. least min always did.Remedy, cut at 45 degs [mitre] and fit into corner, also finnish int same spot. simple and effective ;) ;)if its no fitting even all around, you can , with the aid of an adjustable spanner, bend the steel edges to fit Link to comment Share on other sites More sharing options...
junkuser Posted October 31, 2010 Share Posted October 31, 2010 As Marcus suggested and you can Superglue the joint together.Take care to get the ends together accurately the first time, you don't get a second chance. Link to comment Share on other sites More sharing options...
BodsMk1 Posted November 1, 2010 Author Share Posted November 1, 2010 Thanks guys, i thought that was the way but i still cant get my head around the mitre joint, i cant get the rubber part seal to join , any one got any piccys or more precise instructions , cheers Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.