GT6 Door seal question

[BodsMk1]

Hello , could anyone give me tips on getting my door seals to fit neatly. Im havin a major problem getting them to go around the top back corner because it tighter than 90 degrees, also wheres the best place to finish the seal . All tips welcome , cheers all.

[Velocita Rosso]

The corners, a soft faced mallet and a  small piece of soft wood , gently tapping into the corner
Finish off on the centre/upright near the hinges, the join wont be seen on immediate opening of the door    

[GT6 M]

It will pull out /work out. least min always did.
Remedy, cut at 45 degs [mitre] and fit into corner, also finnish int same spot.  
simple and effective ;) ;)

if its no fitting even all around, you can , with the aid of an adjustable spanner, bend the
steel edges to fit

[junkuser]

As Marcus suggested and you can Superglue the joint together.
Take care to get the ends together accurately the first time, you don't get a second chance.

[BodsMk1]

Thanks guys, i thought that was the way but i still cant get my head around the mitre joint, i cant get the rubber part seal to join , any one got any piccys or more precise instructions , cheers