1360 rear quater valances

[vitesse 68]

Hi the passenager side rear quater on my herald 1360 is shot to bits with lots of holes in -should i repair or put new on ?.
What are the new copys like and where can you get good old panels from , i have tried a few places but no luck   ;)

[midgeman]

REPLACE IT. If it is as bad as you say then it is not worth the time and effort and the rust will probably appear again at some point.

I would recommend T D Fitchet of Telford Shropshire 01952 619585/620434 they produce new ones from the original tooling however you have to bear in mind that the tooling is much older than your 13/60 so they are not perfect but can be made to look the part with very little effort and you will have all new steel that will last for years.

They can also supply the rubber bumper retaining strip.

I hope this helps.

Midgeman.

vitesse_68 wrote:

Hi the passenager side rear quater on my herald 1360 is shot to bits with lots of holes in -should i repair or put new on ?.
What are the new copys like and where can you get good old panels from , i have tried a few places but no luck   ;)