Richard B Posted April 9, 2007 Share Posted April 9, 2007 Anybody got a quick short cut for doing this? I might have to wait till tomorrow to buy a left hand thread 5/16th bolt (or Die) so that I can make an adapter for my slide hammer. Just that I wanted to have the block ready to go to the machine shop in the morning. Link to comment Share on other sites More sharing options...
wakaday Posted April 9, 2007 Share Posted April 9, 2007 You could always try a big washer under the bolt and then gently try to lever it up with a pair of big screwdrivers under the washer. It has worked for me many times in the past.Just be careful not to damage the mating face of the block and wear gloves, dust mask and eye protection (for both eyes) just incase anyone from the HSE gets involved Link to comment Share on other sites More sharing options...
Richard B Posted April 9, 2007 Author Share Posted April 9, 2007 'elf 'n safety Wakaday? I'll have no bad language on this thread!!!!! :)Go and wash your mouth out with hyper-clean..............Thanks for the tip I'll try it now. Link to comment Share on other sites More sharing options...
Richard B Posted April 10, 2007 Author Share Posted April 10, 2007 Cheers Wakaday, worked a treat.and to be honest I did use eye protection......... Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.