TOM Fisher Posted November 27, 2021 Share Posted November 27, 2021 Thanks to the answers in my post yesterday (speedo 10% out)I think the problem is in the number of teeth on the gear so I need to remove the existing drive gear. Its jacked up high, speedo cable removed, the instruction say grip the end of the gear and wiggle it about until it pops out with its bearing, seal and housing. But despite lots of wiggles it will not budge any advice please? Quote Link to comment Share on other sites More sharing options...
yorkshire_spam Posted November 27, 2021 Share Posted November 27, 2021 Still not sure what gearbox you have.... so this might not be good advice! On the 'box I've worked on recently I managed to get the tip of at thin small flat bladed screwdriver between the "bung" that the speedo drive runs through and the case and pry it out far enough to get a bigger flat bladed driver in... "wiggle it out" is a bit like the old haynes "withdraw bolt from housing" (an hour later it's still not out after being brayed with a sledge hammer!) - easier said than done! Quote Link to comment Share on other sites More sharing options...
TOM Fisher Posted November 27, 2021 Author Share Posted November 27, 2021 Thanks for that, it was what I was trying as long as that might well be a solution I will persist again. Cheers Quote Link to comment Share on other sites More sharing options...
Guppy916 Posted March 3, 2022 Share Posted March 3, 2022 When yo put it back together make an inspection port, it's well worth the effort, I have two one for speedo and the other for checking the oil level Quote Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.