Adrianb Posted July 12 Share Posted July 12 I’ve read the two books I have and looked at the diagrams but still need some simple guidance. Does the Bulkhead floor pans go on top or below the rear tub floor pans and does the rubber strip go between the floor pans or the floor pans and chassis? Thank you for your assistance. Quote Link to comment Share on other sites More sharing options...
Matt306 Posted July 13 Share Posted July 13 If I remember correctly on my herald. I put rubber on the outriggers. Then bulkhead as there was a slight down lip then rear tub. Don't think I used a rubber there as it was too thick. Try some sealant just before bolting it down tight. You'll need to move the tub about a bit to get door gaps right. The bulkhead doesn't move due to the tight tolerance hole at the front out riggers. 1 Quote Link to comment Share on other sites More sharing options...
glang Posted July 13 Share Posted July 13 I believe some people open up the bulkhead mounting holes to try to get the bonnet gap right. Otherwise, as is very common to see, you can never get the bonnet close enough to the front edge of the doors☹️ 1 Quote Link to comment Share on other sites More sharing options...
Adrianb Posted July 13 Author Share Posted July 13 Many thanks some good points there, much appreciated. Quote Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.