wiring loom routing

[daneggies1]

Hi everyone in the stages of re wiring my mk3 GT6 and have hit a snag with the wiring which is routing, I have re wired the dash area etc but could anyone tell me the routing of the loom for the rear area (passenger seat backward through night dim relay etc) and also what is the routing for the loom in the engine bay any pics would be of help many thanks

Thanks Dan

I did have a thread for the resto on tssc however this was lost heres a picture of the car as it stands and a couple of before shots

[nang]

First of all...throw the light dimmer relay away.    >:( Looking good though.
Tony.

[daneggies1]

Ah I was waiting for the throw it away comment Tony I had a a spitfire which I did away with the night dim and I certainly plan to do the same here!!
Dan

[stevegt6]

Main rear section goes under pass seat, through hole in cill and up over rear inner arch to rear corner and then across to o/s lights... The front i cant remember off-hand, but i have slightly mod'd mine but mostly goes original route...

Check for continuity of the wires before fitting - rather than assume, in my case, a new loom would be all ok..

[rotoflex]

On my LHD Mk3, the wrapped harness passes through a grommet on the firewall just inboard of where the pedals are bolted


Then it runs to the front clipped to the top of the engine valances, or just runninging across the shock towers if the valances have been removed

[Phwoar]

If it's "runninging" does that mean it's bifurcated and take two different routes?

[Mj17]

nang wrote:

First of all...throw the light dimmer relay away.    >:( Looking good though.
Tony.

Don't bother throwing the NDR out - if you do you need to find a way to re-join all the wires, just remove the (from memory black) earth lead from the NDR!

[FloydP]

The wiring at the front on mine comes out of the bulkhead grommet then is held in by metal tangs along the chassis rail, going under the turret. Don't know if the over the turret was a LHD thing. Mine also has  a few extra wires that you probably won't have but all the existing wires are still in place and can just about be seen in the picture.
Cheers,
Floyd

[daneggies1]

Thanks for the replies everybody i think ive just about got it now

Dan