Gt6s

If that whats bothering you DO NOT GO OUT ! Failing that DO NOT HIT ANYTHING ! You know the risks its your decision alone. Do really you think those who run expensive to priceless cars on track at race speeds are not aware ?

You forgot the Glasgow kiss and the Glasgow smile. Us Bog Trotters have our own versions of the same Ballymena screwdrivers or knocking out of gear going down big hills Ballymena overdrive. The Sandy row special. A Monk by the neck. (Monk Export ale).

I am 63 as well. Drop on floor hit with BFH Big----ing Hammer. WELL KNOWN EFFECTIVE PRESISION ENGINEERING TECHNIQUES. !

Good job. My laptop buggered up BLUE SCREEN While trying and failing to fix it, it fell on the floor and instantly worked again. Happened a few times after. Drop on floor again allways sorted it. #The blue screen thing eventually went away STILL USING IT.

As Nick says NOTHING FITS, MX5 seats are too high a seat base at 6ft 5 I have no chance Gt Spit seats work. I had a pair of Kirkey aluminium race seats in my EFI Gt very thin high density foam padding near the floor but the seat width to acomodate my lard arse created fitting issues had to cut the alloy in the seat corners and beat the rear inner corners of the floor pans to get them in the Gt. Getting in and out of those high sided seats another issue NOT A PRETTY SIGHT. ( Crawl in, Park arse, Roll out. ) Having a buggered back not helpful either.

Who watches the speedo at 160 ? WATCH THE DAM ROAD ! Things happen really fast at 160. Even bends turn into corners.

Those plughole of doom badges were stuck on Jaguars with water soluable glue so they fell off first wash.

Probably. Ones I have chopped up to modify have been splines. Not of use to me

I had a mate who was completly insistant centre bearing could not be changed on a Sprint shaft. Till he was presented with an old one at a club meeting

Big hammer ! BTW No woodruff key. it's splined.

i have done this job on my 3 cars There is not a lot of clearance for these. If your column slider is siezed you can have problems.

The magnetic drain plug for the gearbox fits, worth doing. AND IT IS 3/4 Hex head

1/4 UNF Any motor factors ANYWHERE should have them. UNF PRETTY MUCH STANDARD FOR GREASE NIPPLES. Failing motor factors any hydraulic shop.

Koni are REALLY GOOD ! Sounds like siezed trunnion bush's. Have you renewed those lately ?

Nothing wrong with splined yoke shown Just a little beat up JUST USE THE SUCKER. Changing these is a propper SOB !