Neilriser Posted February 25, 2018 Share Posted February 25, 2018 Hi to all,im after a measurement please if possible,im currently rebuilding the apertures that hold the rear light fittings and the over ridders,the width across the top from seam to seam is 3inches ISH,however when i temporarally fit the over ridder there seams a little to much gap between the side of the rider and the rear light chrome strip?does the light aperture get wider as it gets lower?i take it the rider should be a snug fit? can someone measure from seam to seam at the bottom just where the bracket is that the valence and side valence bolts to please? i hope this makes some sense im about to weld the area but it just doesnt seam right.Thanks Neil Quote Link to comment Share on other sites More sharing options...
Steve AKA vitessesteve Posted February 25, 2018 Share Posted February 25, 2018 On my Vitesse there is is a visible gap between the over rider and lamp. Quote Link to comment Share on other sites More sharing options...
Neilriser Posted February 25, 2018 Author Share Posted February 25, 2018 Hi many thanks for reply,the gap i refur to is not from bottom of light to top of over rider but to the left and right of the over rider i have a gap of 1/4 inch each side i think my aperture is to wide at this point? is there anyone working on a vehicle [or an old tub] with lights and over riders removed that can measure the empty aperture at this point.Neil Quote Link to comment Share on other sites More sharing options...
Anumator Posted March 4, 2018 Share Posted March 4, 2018 Hi, mine measure 8cm Quote Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.