CharlieB
-
Posts
896 -
Joined
-
Last visited
Never
CharlieB's Achievements
-
Yes, got mine out by carefully cutting a slot with a hacksaw then attacking with a big screwdriver.
-
When I said clinch nut I actually meant the ones you fit in metal with a press or hammer, the correct name is hanknut or pemsert. But in fact you could use the type you fit with a rivet gun type thing ie rivnut or nutsert. They only really work in metal. There is another option to fit directly in fibreglass & that's the jacknut (I've got the name right this time) its what Triumph used in the 1500 spoiler (I know because I had to replace one but could only find metric).
-
I made up small stainless steel plates with a clinch nut in the centre (a standard nut welded in place would do just as well) & a 1/8 hole either side. These were rivited to the inside of the fibreglass valences.
-
6204 wrote:The Shocks are from Jigsaw and are the correct model AVO's for the car. They are the correct shocks for a standard or slightly lowered car. I agree with mikeyb, if yours is significantly lowered you will need shorter shocks, shorter compressed length to give you enough travel & shorter extended length so your shorter springs don't come loose on droop. Also search "AVO bushes" the lower bushes on current AVO shocks are poorly designed.
-
93 wrote: I Replaced all the nylon buttons on assembly.... Did you make those youself?
-
Will the carpet take up most of the overhang?
-
2597 wrote:I have bought some greasable UJ's instead of sealed ones. Not sure if I should have bought sealed??? Sealed or greasable are ok but you want Heavy Duty for the driveshaft otherwise you will be replacing them again soon. HD UJ's will typically cost over £20 but are worth it imho. Standard are fine for the propshaft.
-
My swing spring required 18mm diameter buttons, I guess it varies from spring to spring?
-
I turned some up on a lathe using nylon bar of the correct diameter (18mm x 5mm thick IIRC), I'm sure you could use a saw if you're careful.
-
Are you trying to remove the hubs to fit the new studs? Can you not drill a hole in the brake back plate & fit them that way?
-
No the tie rod length does not effect whether or not you get tuck under, only the swing axle length (& angle & spring rate & .....) Obviously rotoflex cars don't suffer from tuck under.
-
rotoflex wrote:Where'd you get the stub stacks for the carbs? They look like APT ones http://www.aptfast.com/
-
The usual choices are 155/80 (std) or 175/70 which gives the same overal diameter so the gearing is the same & the speedo is still accurate. 165/70 might be ok, your speedo will over read slightly. 165/80 would be too big?
-
There's at least 2 different offset 5.5J steels available. Mine are 16mm & I've also seen 3/8" (~10mm) which would be worse. The size & offset is stamped on the rim.
-
For the MkIII the standard offset is 0.88" or 22mm (don't believe the websites that say 0.5") I would think the early cars would be the same? There's no reason to put bigger wheels on the back with all the weight up front unless you're going drag racing :)