stum3 Posted June 3, 2011 Share Posted June 3, 2011 Hi guys my accelerator cable just snappedSo ordered a new one from rimmer brosAnd was going to order a new ht lead dissy and Rotor armBut I first checked my engine number and it starts with dgWhich is a toledo 1300 engine firstly will the cable be okAnd are the dissy etc the same as the spitfite 1300ThanksStu Link to comment Share on other sites More sharing options...
Clive Posted June 3, 2011 Share Posted June 3, 2011 Post a picture! In fact, the dissy is swappable easily, so you can end up with all sorts of bits and bobs. However, if the dissy has a cable take off (like a speedo cable) for the rev counter, and the body of the dissy is steel (not aluminium) then it will be a delco version, from a spitfire.But a picture is always helpful in these situations :) Link to comment Share on other sites More sharing options...
stum3 Posted June 6, 2011 Author Share Posted June 6, 2011 Hi Thanks pic attached Link to comment Share on other sites More sharing options...
Tom2000 Posted June 7, 2011 Share Posted June 7, 2011 Suspect you may need to post a closer shot. Link to comment Share on other sites More sharing options...
Clive Posted June 7, 2011 Share Posted June 7, 2011 I spy delco distributer, so off a spitfire..... Link to comment Share on other sites More sharing options...
stum3 Posted June 8, 2011 Author Share Posted June 8, 2011 Thanks I have ordered spit mk3 1300 cc bits as rimmerBros advised when I sent them this photo Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.