SteveJP Posted October 7, 2006 Share Posted October 7, 2006 I am shortly going to replace the BMC on my Stag as it is leaking - the manual says remove the complete unit with Servo before dismantling the master cylinder - is this neccessary, or can I just drain the cylinder, disconnect the hydraulic pipes and remove the two bolts holding the BMC to the servo unit? Link to comment Share on other sites More sharing options...
nibby Posted October 7, 2006 Share Posted October 7, 2006 I replaced the seals on mine the other day. It is difficult to remove the bolt nearest the wing but can be done, I left the servo in situ but fully understand it would be easier with the servo removed.Best of luck Link to comment Share on other sites More sharing options...
shenderson Posted October 10, 2006 Share Posted October 10, 2006 I found it's a real fiddle to remove th ecylinder without also removing th eservo.I got an exchange master cyl. from Past Parts in Bury St Edmunds - http://www.pastparts.co.uk/ - they bore out and resleeve them and exchange for about £100. Excellent service.Steve Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.