brucy Posted May 29, 2006 Share Posted May 29, 2006 Ok, stupid question timeHow is the rear seat back held in? I've undone the screws from the top (convertable) but it doesn't want to move, and i don't want to force and rip! I have found some black triangular bits at each end but these don't want to move either!Is there anything i've missed? Link to comment Share on other sites More sharing options...
Jason Posted May 29, 2006 Share Posted May 29, 2006 Pop rivets all round through the hood bag poppers Link to comment Share on other sites More sharing options...
bxbodger Posted June 2, 2006 Share Posted June 2, 2006 Sorry, I'm a bit late on this, (been on my hols..) but if its still stuck, according to the factory workshop manual there are 2 extra screws down each side of the seat back, halfway down in the sides of the hood-well.Mine was hard to shift as well, and I looked in the manual for less obvious fixings that I'd missed and it showed these. As it happens, they were missing from mine, but yours may still be there!!It turned out on mine that the metal bit of the seatback was wedged pretty tightly over the support frame and it took a really good pull to shift it. Link to comment Share on other sites More sharing options...
brucy Posted June 2, 2006 Author Share Posted June 2, 2006 Sorry didn't update this, it was glued. Went gung-ho on it and it slowly peeled off :) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.