Mollysdad Posted November 27, 2015 Share Posted November 27, 2015 Quoted from Nick Jones No. The spring sides of the seals should both face into the bearing assembly.Propshaft sliding spline usually has a blanking plug located at the UJ end of the female section, which is removed to temporarily fit a grease nipple.Nick Thanks again! Quote Link to comment Share on other sites More sharing options...
daver clasper Posted November 28, 2015 Author Share Posted November 28, 2015 HiWhen greasing the propshaft sliding spline, where does the old grease exit from please.Cheers, Dave Quote Link to comment Share on other sites More sharing options...
Nick Jones Posted November 28, 2015 Share Posted November 28, 2015 Should come out under the screw cap if anywhere. Don't over do it - could fill the pocket at the UJ end and "hydraulic lock" it.Nick Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.