GT6 M Posted January 19, 2014 Share Posted January 19, 2014 For any one with the High Torquey starters,this may be of some intrest.A few times gon to car, and starter just cliks, a couple of cliks an its goingtoday, nothing.So off it comes, and on the end nearest the ex pipestheres an end cap, 3 screws od,n it on,in there, there 2 contacts either side, and a bigg copper washer in the center solonoid bitThe copper washer and the contacts had corroded up. moisture / rust ect.quick clean up, and vaselined up, and good as new.BUTTT, where the water come frae, there a seal on end,,bunged some sealant on there for good measure.BUTTTT, looking at the other end, where its been shaved doon, there were break thru holes, so water must,v been getting in there, and running thru to other end,hence the fair amount O rust in the solonoid bit.sealed em up, so hope fully its sealed it noo.Note, it can be done on the car, screws are only 1/2 inch long. and rest pulls oot.but I did,nt no what was needed. hence it had to come off.Butt, 15 odd e,a with no probs frae it. mus,nt grumble.may be of intrest to some, save ye some loot no tek,n it to a garage.!!M Quote Link to comment Share on other sites More sharing options...
TedTaylor Posted January 20, 2014 Share Posted January 20, 2014 Thanks Marcus, something to remember.MUT Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.