George Posted March 2, 2013 Share Posted March 2, 2013 Hi gang, me again.....So, both turrets are back on the car, with the jack dropped. I put the engine mounts on the outside of the turrets if that makes sense (this may be where i went wrong....). Does it seem to be at too much of an upward angle??Here are the shots below. it all seems to be too high at the front to me. Cheers, George Quote Link to comment Share on other sites More sharing options...
SveinHa Posted March 3, 2013 Share Posted March 3, 2013 Maybe this can be of some help:The engine is almost resting on the steering rack. Quote Link to comment Share on other sites More sharing options...
JohnD Posted March 3, 2013 Share Posted March 3, 2013 George,The front turrets are desigend to be canted like that, and to mount the engine slight tlited backwards.The holes in the chassis rails dictate this and unless they have worn oval, most unlikely, then the angle is correct.See series of artilces in Courier, 159-162, by Carl Heinlein, and this diagram (it's a Word file, so clik con on it to see the picture)John Quote Link to comment Share on other sites More sharing options...
George Posted March 3, 2013 Author Share Posted March 3, 2013 Thank you both. Here is a shot from the front. I just dont remember it being so high above the brake line, i may be wrong though. Quote Link to comment Share on other sites More sharing options...
CHRIS211083 Posted March 3, 2013 Share Posted March 3, 2013 Looks fine to me. Only question would be were did you mount the rear mounting plate? Under the xchassis lip or over the chassis lip? It will only make a small difference but this could change the look.Chris. Quote Link to comment Share on other sites More sharing options...
George Posted March 5, 2013 Author Share Posted March 5, 2013 2402 wrote:Looks fine to me. Only question would be were did you mount the rear mounting plate? Under the xchassis lip or over the chassis lip? It will only make a small difference but this could change the look.Chris.Hi Chris, Rear mounting plate...? The novice in me is needing some clarity ;) Cheers, George Quote Link to comment Share on other sites More sharing options...
Curtis1360Barry Posted March 5, 2013 Share Posted March 5, 2013 He means the gearbox mounting plate! C Quote Link to comment Share on other sites More sharing options...
George Posted March 5, 2013 Author Share Posted March 5, 2013 4535 wrote:He means the gearbox mounting plate! CAahhh i see. I didn't remove the block, so all is as it was... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.