oldbury863 Posted September 23, 2020 Share Posted September 23, 2020 Early on in my (1970) 13/60 rebuild I decided to discard the old inertia seat belts (error). I have just purchased a pair of new Securon 300/30 static belts to replace them. Whilst the floor mountings both appear the correct size (11/16"AF), the B pillar mounting hole is too small! I have one bolt that fits and its an M10. Is this curious combination normal? The M10 is actually slightly smaller than the 11/16 so it cant have been re-tapped. Can anyone shed any light please? Quote Link to comment Share on other sites More sharing options...
RobPearce Posted September 23, 2020 Share Posted September 23, 2020 Anything metric is definitely not correct. All original seat belt fixings were 7/16 UNF with 11/16" AF heads. Where is the B-pillar hole? The original factory static belts were attached to the waist rail about 6 inches behind the B-pillar, except on convertibles (you don't say which body yours is) where they attached to the rear wheel arch and were fed through a slot in the side trim panel. Quote Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.