mickeywheelspin Posted June 19, 2007 Share Posted June 19, 2007 Probably a daft question, but why break the habit of a lifetime ;)I'm currently replacing the wiring loom on my mk 3 spit and all is going well except that I can't figure out how to fit the connectors to the fuse box. I was expecting the usual type of spade connector, but have these which I've not seen before. I'm a little loathed to cut them off and crimp on new connectors unless I have to, but I can't work out how they fit.Any pointers welcome.Mike Link to comment Share on other sites More sharing options...
Clive Posted June 19, 2007 Share Posted June 19, 2007 They look as they slot in the fusebox and (in pairs) hold the each end of the fuses. If that makes sense. Link to comment Share on other sites More sharing options...
CharlieB Posted June 19, 2007 Share Posted June 19, 2007 Assuming your fuse box hasn't melted, they just push in from the back & click as the tags snap into place. Link to comment Share on other sites More sharing options...
Deleted User Posted June 19, 2007 Share Posted June 19, 2007 yeah each of those is half of what you are expecting, there is a wee clip on the outside that holds them in the fuse box. Link to comment Share on other sites More sharing options...
mickeywheelspin Posted June 19, 2007 Author Share Posted June 19, 2007 Doh! Hadn't thought they might push all the way through... I'll look for tell tale holes / slots tomorrow.Thanks,Mike Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.