mazfg Posted October 12, 2017 Share Posted October 12, 2017 Hi, just had a question about these. Looking at the pivoting dowels on these, should they lean in slightly towards the main arm of the lever? Or should they be straight up towards each other? (example pics below..not my one)Thanks Quote Link to comment Share on other sites More sharing options...
Pete Lewis Posted October 14, 2017 Share Posted October 14, 2017 Straight .... the other one is bentof they have flats worn on you can drill them out and weld in a clevis pin as a repairif the throwout is only 15mm thick add a washer under the lightly pressed in spherical post this realigns the lever as orig bearing was 19 mm thick all the losses add up poor action.if the carrier has worn by the lever pins ,remove the anti rotaion pin and drill elswhere to use some unworn groovepete Quote Link to comment Share on other sites More sharing options...
Paudman Posted October 14, 2017 Share Posted October 14, 2017 I thought that was two pics of the same lever, just either side? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.