TimW Posted February 14, 2013 Share Posted February 14, 2013 I HAVE A 2.5L SALOON ENGINEI have measured the endfloat at 0.009" The front bearing is STD and the rear is +.005" Now the workshop manual for a GT6 (dont have a saloon manual) says endfloat between .004" and .008" is this correct for the saloon engine?My question is do I replace the rear for a 0.010" and leave the front as STD or leave the 0.005 in the rear and change the front to 0.005? whatever one i increase in size should i also change the other for a new one? Quote Link to comment Share on other sites More sharing options...
Nick Jones Posted February 14, 2013 Share Posted February 14, 2013 Don't think it matters much. Both should put where you want to be. I usually use whatever combination I happen to have in "stock". I also aim to get them at the tight end of the spec as I reckon you gain a couple of thou in the first few minutes of run time.Nick Quote Link to comment Share on other sites More sharing options...
TimW Posted February 14, 2013 Author Share Posted February 14, 2013 Nick_Jones wrote:Don't think it matters much. Both should put where you want to be. I usually use whatever combination I happen to have in "stock". I also aim to get them at the tight end of the spec as I reckon you gain a couple of thou in the first few minutes of run time.Nickin that case I think I will get a pair of +.005" and then I know they are both new 8) 8) Thanks Nick Quote Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.