Paudman Posted November 6, 2014 Share Posted November 6, 2014 Anyone found the collar for the SimonBBC electronic ignition to be too thick when fitted around the centre spindle, holding the red rotor arm just slightly too high so that it never clips on right? My GT6 dizzy never seems to have the arm on tightly enough; I suppose it’s held on by the cap but I’d rather have it click into place. I’ve got starting problems at present and am trying to eliminate any culprits. Anyone tried skimming theirs slightly? Quote Link to comment Share on other sites More sharing options...
thescrapman Posted November 6, 2014 Share Posted November 6, 2014 I know they do not push down far enough sometimes.measure the depth and compare tohow far it sits.CheersColin Quote Link to comment Share on other sites More sharing options...
dinger Posted November 6, 2014 Share Posted November 6, 2014 Trimmed the collar off from mine to allow the rotor arm to drop .Also needed to lift moving sensor ring up the shaft to allow it to generate spark Quote Link to comment Share on other sites More sharing options...
nang Posted November 7, 2014 Share Posted November 7, 2014 Get a Pertronix (eek)(eek)Tony. Quote Link to comment Share on other sites More sharing options...
Paudman Posted November 19, 2014 Author Share Posted November 19, 2014 1279 wrote:Trimmed the collar off from mine to allow the rotor arm to drop .Also needed to lift moving sensor ring up the shaft to allow it to generate spark I suspected I might need to trim the collar but how do you raise the sensor ring?(Pertronix a non-starter.) Quote Link to comment Share on other sites More sharing options...
.thumb.jpeg.b15b81ef10abeea1c3039ae03c4a9f3a.jpeg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.