glang Posted November 16, 2022 Share Posted November 16, 2022 Its going to be tight according to Canleys info: Quote Link to comment Share on other sites More sharing options...
RobPearce Posted November 16, 2022 Share Posted November 16, 2022 The Vitesse propshaft has a sliding spline with about two inches movement, so there's probably an inch of compression available. That's enough for a non-OD Vitesse prop to work OK on a 3-rail OD Herald but not with a single rail. Quote Link to comment Share on other sites More sharing options...
Wendy Dawes Posted November 16, 2022 Author Share Posted November 16, 2022 I’ll need to contact Canley to see what they suggest I always knew it wouldn’t be a straightforward job 🙄👍 Quote Link to comment Share on other sites More sharing options...
Clive Posted November 16, 2022 Share Posted November 16, 2022 17 minutes ago, Wendy Dawes said: I’ll need to contact Canley to see what they suggest I always knew it wouldn’t be a straightforward job 🙄👍 https://www.canleyclassics.com/?archive=propshaft-problems 1 Quote Link to comment Share on other sites More sharing options...
glang Posted November 16, 2022 Share Posted November 16, 2022 28 minutes ago, Wendy Dawes said: I’ll need to contact Canley to see what they suggest I always knew it wouldn’t be a straightforward job 🙄👍 Actual measurement is the only way - cars vary and it might turn out to be doable especially as being a 4 cylinder you have much more margin for 'adjustments'... 1 Quote Link to comment Share on other sites More sharing options...
mpbarrett Posted November 17, 2022 Share Posted November 17, 2022 rather than try to find a good used propshaft I would go for a new one. There is nothing worse than a Herald with an out of balance propshaft...... mike 1 Quote Link to comment Share on other sites More sharing options...
glang Posted November 17, 2022 Share Posted November 17, 2022 The workshop manual says a fully closed non OD Vitesse prop measures 1188.5mm.... 1 Quote Link to comment Share on other sites More sharing options...
Wendy Dawes Posted November 17, 2022 Author Share Posted November 17, 2022 1 hour ago, mpbarrett said: rather than try to find a good used propshaft I would go for a new one. There is nothing worse than a Herald with an out of balance propshaft...... mike Yes my 1360 had one, it shook like hell at around 45mph lol Quote Link to comment Share on other sites More sharing options...
glang Posted November 24, 2022 Share Posted November 24, 2022 Soon have a first gear ratio thats actually useful and be flicking the overdrive in for smooth high speed cruising😊 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.